Jump to main content
Hoshizaki logo

Hoshizaki appliance repair in San Antonio, TX.

We service Hoshizaki ice machines as light-commercial equipment, and in San Antonio hard water drives most of the calls.

Phones staffed 24/7Three-hour arrival window90-day parts warranty

Diagnosis
The failed part is found before any price
Approval
No work begins without your okay
Hours
Calls answered day and night
Warranty
Parts 90 days · labor 30 days

Book online

Send the basics. A dispatcher calls you back.

  1. 1Describe the problemYour ZIP code, the appliance, and the trouble it is giving you.
  2. 2Pick up when we callWe confirm the address and set a three-hour arrival window.
  3. 3Get one priceThe technician diagnoses it, then quotes parts and labor together. The diagnostic fee is credited if you go ahead.

Would rather explain it out loud? Call us any hour, any day.

Schedule a repair

Step 1 of 2 · Appliance and area

Step 1 of 2

Appliance and area

Which appliance?

Appliance

Where in the San Antonio area?

Booking costs nothing, and we never ask for a card.

Prefer to call? (210) 939-3313

Light commercial

Hoshizaki appliances we repair

What fails most on Hoshizaki

  • Scale on the evaporator causing thin, cloudy or ragged cubes
  • Weak water pump, restricted water circuit or clogged filter
  • Hot-gas harvest faults leaving ice stuck to the plate
  • Condenser clogged by kitchen air
  • Float switch stuck with scale or water level faults

Hoshizaki, plainly

What usually goes wrong

Hoshizaki, a Japanese manufacturer, is known first for commercial ice machines and also makes refrigerated and freezer cabinets for food service. Most likely yours is in a café, bar, restaurant, office break room or church kitchen.

  • Ice Maker

    The cubes look cloudy or ragged, and the bin fills slower than it did.

    Usually scale has coated the evaporator, so batches take longer and the cubes come out rough. A full descale and sanitize often restores it.

  • Ice Maker

    The machine runs, but ice stays stuck to the plate instead of falling.

    Usually scale has the ice stuck to the evaporator, or a harvest fault means it never lets go.

  • Refrigerator

    The reach-in warms up during the busiest part of the day.

    Often kitchen grease has caked the condenser, or the door seals no longer close tightly.

  • Freezer

    Frost covers the coil and the cabinet is slowly getting warmer.

    Usually a defrost problem or a door that isn't closing all the way.

  • Ice Maker

    Water overflows, or the machine stops filling.

    The float switch is often stuck with scale, or a clogged water filter is starving the machine.

Check this before you call

  1. Check when the water filter was last replaced, and swap it if it's past due.
  2. Check that the machine's water supply valve is open all the way.
  3. Keep boxes and dust away from the air vents and condenser grille.
  4. Confirm that the bin door and any reach-in doors close fully.

Commercial equipment

Servicing Hoshizaki equipment

Commercial ice machines are what made the Hoshizaki name. The calls we get are for falling output, thin or cloudy cubes, and problems with scale, a water pump or a spent water filter. San Antonio's hard tap water scales an evaporator steadily, and businesses on Hill Country wells can see faster scaling or staining depending on their water.

  • KM Series cubers
  • Flaker and cubelet ice machines
  • Undercounter ice makers
  • Reach-in refrigeration

Worth checking before you call

  • • If ice production is down, change the water filter first, then schedule a descale.

From our technicians

Working on Hoshizaki equipment

July is when San Antonio finds out how healthy its ice machines are. A Hoshizaki cuber that kept up in spring starts falling behind as afternoons pass 100 degrees, the bar goes through ice faster than ever, and the condenser is pulling in hot kitchen air. Restaurants, bars, offices, churches and catering kitchens all feel it at once.

Most of the time the machine is not broken. It is scaled, its filter is spent or its condenser is dirty, and output has been sliding for weeks. We measure what it is actually producing and compare that against what it should.

What sets Hoshizaki apart

Hoshizaki is a Japanese company focused on commercial ice machines and the matching reach-in refrigeration, and it designs its own machines. In its KM series cubers, water flows over a vertical stainless evaporator, and a hot-gas harvest releases the ice as a hard, slow-melting crescent cube. Water quality matters most on these machines: scale on the evaporator gradually cuts output and roughens the cubes well before any part fails. Parts come through specialist foodservice distribution.

We judge a Hoshizaki against its rated output, not by whether there is still ice in the bin. Plenty of Hoshizaki problems go away after a full descale and sanitize done the manufacturer's way, and if that's all the machine needs, we say so and skip selling you a board. If a part has genuinely died, we swap it, then let the machine run a few production cycles so we can confirm both output and cube quality.

Edwards Aquifer water on a stainless evaporator

The limestone in most San Antonio tap water ends up on the evaporator plate of an ice machine. Each harvest takes a little longer, cubes come out thinner or cloudier, and eventually ice sticks to the plate instead of releasing. That looks like a harvest valve or board failure but usually is not.

A full descale and sanitize to Hoshizaki's procedure, plus a fresh water filter, restores many machines to rated output. Businesses on private wells in the Hill Country can see faster scaling or staining depending on their water.

When something has actually failed

With the water side clean, real faults stand out: a weakened water pump, a float switch that can't read the level, a hot-gas valve that won't open for harvest, or a condenser fan that no longer spins. Air-cooled machines in a hot back room or tight bar space suffer most, because the condenser cannot shed heat.

Once a repair is done, we run production cycles to confirm the machine is making the ice it should, at the quality it should, before we leave.

What to have ready, and what to keep up

When you call, tell us the model, whether it is a cuber, flaker or undercounter unit, when it was last cleaned and when the water filter was changed. Note whether output dropped slowly or the machine stopped suddenly, since those point in very different directions.

Keeping to the cleaning schedule, changing filters on time and keeping boxes away from the air vents are what let an ice machine last many years instead of a few.

Questions

Hoshizaki repair questions

Our Hoshizaki still makes ice. Why would it need service?

If output has dropped or the cubes come out thin, cloudy or ragged, scale is usually robbing the machine of efficiency. We measure output against the rating instead of judging by the bin.

For a San Antonio ice machine, what's the right cleaning schedule?

Follow Hoshizaki's schedule as a minimum. On hard local water, many businesses need cleaning more often, especially through the summer.

Ice is sticking to the plate instead of dropping. What causes that?

Scale holding the ice in place is the most common reason. A harvest problem is the other possibility, and we check it once the evaporator is clean.

Do you service Hoshizaki reach-ins too?

Yes. Warm cabinets usually trace to a dirty condenser, worn door gaskets or a defrost issue, the same as other commercial refrigeration.

How often should we clean the ice machine?

Stick to the manufacturer's schedule, and clean more often on hard water like San Antonio's. Descaling regularly keeps production up and the cubes clear.

It still makes ice. Does it really need service?

Yes, if the cubes look wrong or output has dropped. We check what the machine ought to produce, not only whether ice appears.

Does the water filter matter that much?

It does. Hard or unfiltered water builds scale on the evaporator faster, and that scale is behind many service calls for these machines.

Hoshizaki acting up?

Tell us the model and the symptom. A person answers 24/7.

Call now, 24/7(210) 939-3313Book online