Everest appliance repair in San Antonio, TX.
Phones staffed 24/7Three-hour arrival window90-day parts warranty
- Diagnosis
- The failed part is found before any price
- Approval
- No work begins without your okay
- Hours
- Calls answered day and night
- Warranty
- Parts 90 days · labor 30 days
Book online
Send the basics. A dispatcher calls you back.
- 1Describe the problemYour ZIP code, the appliance, and the trouble it is giving you.
- 2Pick up when we callWe confirm the address and set a three-hour arrival window.
- 3Get one priceThe technician diagnoses it, then quotes parts and labor together. The diagnostic fee is credited if you go ahead.
Would rather explain it out loud? Call us any hour, any day.
Schedule a repair
Step 1 of 2 · Appliance and area
Light commercial
Everest appliances we repair
What fails most on Everest
- Hinge cartridges worn so doors no longer close themselves
- Gaskets torn or flattened on high-traffic doors
- Defrost ending early so the evaporator slowly ices over
- Fouled condenser overworking the compressor
- Drain line clogged in the cabinet base
Everest, plainly
What usually goes wrong
Everest builds commercial refrigeration for food businesses, including reach-ins, undercounter units and prep tables. Owners are mostly restaurants, cafés, delis and bars, plus the occasional homeowner with a commercial reach-in working hard in the garage.
- Refrigerator
The reach-in is fine overnight but warms up during the lunch rush.
Usually the doors have stopped sealing well, or kitchen grease and dust have coated the condenser. Heavy traffic just makes it obvious.
- Refrigerator
The cabinet below stays cold, but the rail on the prep table runs warm.
Often the lid stays up during service, or pans are packed so tightly that air can't reach the rail.
- Freezer
Ice is building on the coil and the box is slowly losing temperature.
A defrost cycle that ends too early, or a door left slightly open that keeps feeding moisture inside.
- Freezer
Water is collecting on the cabinet floor.
Most often the coil's drain line has clogged and water backs up during defrost.
- Refrigerator
The back of the unit runs very hot and the compressor never seems to shut off.
The condenser is often clogged so the system can't get rid of heat. Left alone, that shortens compressor life.
Check this before you call
- Give each door a gentle push and see whether it closes and seals by itself.
- Look along the gaskets for torn or flattened sections.
- Keep boxes and clutter off the condenser grille so nothing blocks the airflow.
- Check that nobody changed the thermostat setting during a shift.
Commercial equipment
Servicing Everest equipment
Food and drink businesses buy Everest Refrigeration reach-ins, prep tables and bar coolers. Our most common jobs on them: worn door gaskets, condenser or evaporator fan motors, temperature controllers that have failed, refrigerant leaks, and dirty coils that need a deep clean.
- Reach-in refrigerators and freezers
- Prep tables
- Bar and back-bar coolers
- Glass-door merchandisers
Worth checking before you call
- • If the cabinet warms up during a rush, with staff opening the door nonstop, check the gasket and the condenser before you blame the compressor.
From our technicians
Working on Everest equipment
Everest units hold the cold side of a lot of San Antonio businesses: reach-ins at a neighborhood restaurant, prep tables on a busy line, bar coolers at a River Walk-area bar, glass-door merchandisers in an office or a church kitchen. They're simple machines, and nothing inside is proprietary enough to leave the unit stranded.
We treat them as light-commercial equipment. That means working around your hours where we can, finding the real cause rather than the first failed part, and leaving a written note for your records.
What sets Everest apart
Everest Refrigeration builds affordable commercial reach-ins, undercounter units, prep tables, bar coolers and glass-door merchandisers. The units use standard self-contained refrigeration, and their condensing units, controllers, probes and door parts are common commercial components rather than proprietary ones, so parts are easy to find. Doors decide how long an Everest lasts: once a door stops swinging shut or a gasket goes flat, warm air leaks in all day, a load the system wasn't built to carry.
We service Everest units as light-commercial refrigeration. Before testing anything electrical, we check that each door closes and seals by itself, because worn hinge cartridges and gaskets can wear down a compressor that otherwise tests fine. When a problem traces back to cleaning or door habits, we say so. Commercial calls are prioritized, and you get a written service note.
Doors first, then everything else
A commercial door gets opened all shift long. When its hinge cartridge weakens and the door stops swinging closed, or the gasket flattens at a corner, warm, humid air pours in. The compressor runs longer, the evaporator ices up, and the drain carries more water than it was meant to.
That is why we push each door, look at every gasket and check the hinges before we test the controller or the sealed system. Replacing a worn hinge cartridge or gasket is a small repair that protects the most expensive part of the unit.
The July rush
San Antonio kitchens and bars run hot in summer, and a reach-in that held fine in spring can drift warm through lunch once afternoons pass 100 degrees. A condenser coated in grease and dust cannot shed heat in a hot room, so the unit runs without cycling off and the back of the cabinet gets very hot.
Brushing the coil, keeping boxes away from the grille and making sure the unit is not tucked against a fryer line prevent most of those calls. When the coil is clean and the box still drifts, we look at fans, defrost and refrigerant charge.
What to have ready when you call
Tell us whether the unit is still holding product safely, when the problem started, and whether it gets worse during service. Note whether water is collecting inside the cabinet, since that points us toward the drain and defrost.
The model and serial label usually sits up near the top of a side wall inside the cabinet; on prep tables, check inside the base. With that, we can bring the likely gasket, fan or controller on the first trip.
Questions
Everest repair questions
Our Everest is warm during lunch but fine overnight. What is going on?
Heavy door traffic and a hot kitchen expose weak gaskets, a door that does not close itself or a dirty condenser. We check all three before looking at the compressor.
How can our staff help prevent breakdowns?
Keep the condenser grille clear, shut the doors fully, and tell us about any door that won't swing closed by itself. Those habits head off most failures.
Why is water collecting on the cabinet floor?
Usually the drain line from the evaporator is clogged and backs up during defrost. Clearing it, and fixing whatever is letting in extra moisture, solves it.
How quickly can you reach a commercial unit?
Commercial refrigeration calls are prioritized because the food in the box is at stake. Before we go, you also get a written note: the fault, then the fix.
How can my staff help keep it running?
Keep the condenser clear, close doors all the way, and report any door that won't swing shut. Those three habits prevent most failures.
Are Everest parts hard to come by?
Usually not. Most parts are standard commercial components, so waits tend to be short.
Everest acting up?
Tell us the model and the symptom. A person answers 24/7.