Roper appliance repair in San Antonio, TX.
Phones staffed 24/7Three-hour arrival window90-day parts warranty
- Diagnosis
- The failed part is found before any price
- Approval
- No work begins without your okay
- Hours
- Calls answered day and night
- Warranty
- Parts 90 days · labor 30 days
Book online
Send the basics. A dispatcher calls you back.
- 1Describe the problemYour ZIP code, the appliance, and the trouble it is giving you.
- 2Pick up when we callWe confirm the address and set a three-hour arrival window.
- 3Get one priceThe technician diagnoses it, then quotes parts and labor together. The diagnostic fee is credited if you go ahead.
Would rather explain it out loud? Call us any hour, any day.
Schedule a repair
Step 1 of 2 · Appliance and area
Everyday brands
Roper appliances we repair
- Roper refrigerator
- Roper washer
- Roper dryer
- Roper dishwasher
- Roper oven
- Roper microwave
- Roper freezer
- Roper cooktop
- Roper range & stove
What fails most on Roper
- Washer drive coupler or belt worn out
- Lid switch or door latch failure
- Drain pump clogged with small items
- Refrigerator cold control or defrost thermostat failing
- Dryer thermal fuse blown by a clogged vent
Roper, plainly
What usually goes wrong
Roper is a Whirlpool value brand that has been sold for decades as the plain, no-extras option. Yours is likely a Roper washer, dryer, range or refrigerator bought simply to get the job done, perhaps in a rental or out in the garage.
- Dryer
The light comes on, but the dryer will not start.
Most often a thermal fuse has blown, and that is usually because the vent is clogged. A bad door switch is the other likely answer.
- Washer
It grinds or bangs loudly during the spin.
A coin or small object is often stuck in the pump or tub area. On an older top-loader, that noise can also come from tired suspension parts or a drive component that has worked loose.
- Range & Stove
One electric burner stays cold while the rest heat up.
The coil element has usually failed, or its socket has burned. Both are plain parts and quick to replace.
- Refrigerator
The fridge runs too cold and freezes produce.
Maybe the cold control is set too low, or it never switches off. So can a damper that is stuck open between the two sections.
- Dishwasher
Glasses and plates come out gritty or filmy.
A dirty filter or plugged spray arm holes are typical. Hard water and too little rinse aid make it worse.
Check this before you call
- With the dryer running, feel for air at the outside or roof vent cap; weak airflow means a clog.
- Check that nobody bumped the refrigerator dial to its coldest setting.
- If the dryer or range shows no sign of life at all, flip its breaker off and back on.
- Ease the washer forward and check that the drain hose behind it is not kinked.
From our technicians
Working on Roper equipment
Roper appliances are everywhere in San Antonio rentals, starter homes and garages: the washer and dryer in an apartment near the Medical Center, the range in a 1960s ranch home inside Loop 410, the spare fridge in the garage. They are built to a price and do the basics well.
The technician diagnoses the Roper, tells you what failed, and gives a single price for parts and labor. Nothing is done until you approve. Common Whirlpool wear parts are often on the van, so plenty of Roper repairs finish on the first visit. For a Roper part that needs ordering, you are told the wait, and we lock in the second visit before the technician heads out.
We do not perform manufacturer-warranty work.
What sets Roper apart
Roper is Whirlpool's long-running value brand, built on the same high-volume Whirlpool platforms with simpler controls and fewer features. A Roper washer, dryer, range or refrigerator uses plain mechanical parts drawn from the wider Whirlpool catalog, so pieces are cheap and easy to find even for older units. With little electronics to interpret, diagnosis is usually quick. The trouble is that a new Roper is cheap too, and that colors every repair decision.
We keep Roper visits short and honest. The parts that usually wear out, such as couplers, lid switches, thermal fuses, drain pumps and defrost parts, are commonly on the van, so many repairs finish on the first trip. If a major repair on an older Roper would cost nearly as much as a new one, we tell you that rather than quote it.
Whirlpool parts in a simpler package
A Roper is a Whirlpool platform with the extras stripped away. That is good news for repairs. Drive parts, pumps, switches, igniters and defrost components are shared with the huge number of machines Whirlpool has built, so they are cheap and easy to find even for a Roper that is ten or fifteen years old.
Fewer electronics also means faster diagnosis. On a mechanical-timer washer or dryer, a meter and a few minutes usually find the fault without any control board to interpret.
Attic dryer vents and blown fuses
Plenty of San Antonio homes run the dryer vent up into the attic and out through a roof cap. That is a long, hot run, and it loads up with lint. If a Roper dryer powers up but won't start, the usual cause is a blown thermal fuse, and that fuse nearly always blew because the vent is clogged. Swapping the fuse while the vent stays clogged only sets up the next failure, along with a real fire hazard.
We check airflow at the vent before calling the repair done, and if the run needs a full cleaning, we tell you.
Garage refrigerators, hard water and freezes
Basic Roper top-freezer refrigerators often end up as garage fridges, where summer heat makes them run almost constantly and dust coats the condenser. Clearing the coil and checking the cold control and defrost parts solves many of these calls. In a hard freeze like the February 2021 storm, a garage fridge can also act strangely as the freezer warms up when the garage gets too cold.
Washers suffer from hard SAWS water too. Scale and grit collect on the inlet screens, and filling slows down. Freezes can also split washer hoses in garages and exterior-wall laundry rooms, so it is worth a look after a cold snap.
Repair or replace on a budget brand
A coupler, belt, lid switch, pump, fuse or element is almost always worth fixing. A failed transmission, sealed-system leak or main control on an older Roper often is not, because a new one costs little more. We give you the price either way, and for rental owners and military families moving on PCS orders, we can tell you plainly which option fits the time you expect to keep it.
Questions
Roper repair questions
My Roper dryer runs but will not heat. What usually causes that?
Electric models often lose an element or thermal fuse; gas models, an igniter or gas valve coil. In most cases the root cause is a restricted vent, so we check that too.
Is it worth fixing a Roper washer?
For a coupler, lid switch, belt or drain pump, yes. Those are inexpensive parts. When an older Roper needs a transmission or another major repair, replacing it is often the smarter way to spend your money.
Why does my Roper garage fridge struggle every summer?
A garage in a San Antonio summer is far hotter than a kitchen, so the condenser has a hard time shedding heat. A clean coil, a few inches of clearance and a working condenser fan help a lot.
Can you still get Roper parts?
Yes. Roper and many Whirlpool machines use the same parts, which keeps the everyday pieces in stock and often already on our van. That keeps small repairs fast.
Should I repair my Roper or buy a new one?
For a switch, belt, fuse or pump, repairing usually makes sense. When an older Roper suffers a major failure, the money may do more good toward a replacement, and you will hear that from us.
Roper acting up?
Tell us the model and the symptom. A person answers 24/7.